Air Driven Stainless Steel 2 Diaphragm Pump Printing Ink Pumps
Stainless Steel Diaphragm Pump is an air operated double diaphragm pump, which is driven by air.
It is a kind of positive displacement pumps which volume changes
caused by compressing diaphragms in both side. This pump not only
can exhaust the flow liquid, but also can convey some uneasy flowed
medium, with the merits of self priming pump, slurry pump and
impurity pump, etc.
Air diaphragm pump(also know as a Membrane pump, air operated double diaphragm pump(AOOD) or pneumatic diaphragm pump)that uses a combination of the reciprocating action of a
rubber,thermoplastic or diaphragm and suitable valves either side
of the diaphragm (check valve,butterfly valves,flap valves,or any
other form of shut-off valves) to pump a fluid.
Specifications
Air Diaphragm Pump
1. Non leakage
2. Good self priming performance
3. Convey all kinds of medium
4. Material:Cast steel,Alu,SS,PP
| Item | Description | Unit | Reference Figure |
| 1 | Maximum air inlet pressure | Mpa | 0.83 |
| 2 | Maximum flow rate | L/Min | 378 |
| 3 | Maximum lift | M | 70 |
| 4 | Maximum outlet pressure | Mpa | 0.83 |
| 5 | Maximum particle size | mm | 6 |
| 6 | Weight | kg | 23 |
| 7 | Noise level | db | ＜70 |
Application:
It is widely applied in waste water treatment, chemical industry,
petrochemical
industry, painting, ceramics, environmental protection, printing
and dyeing, etc. to deal with all kinds of
corrosive, volatile, flammable, poisonous fluids with particles and
high viscosity.
A 40 X X - X X X - X (model selection)
Form of pipe mouth:A-BSP B-NPT(F) C-Flange
Diaphragm material:9 – Santoprene H – Hytrel T - PTFE/Santoprene
Ball material:9 -Santoprene H – Hytre T – PTFE A - Acetal
Ball seat material:P/K –Polypropylene/Kynoar SS –Stainless Steel
Pump material: SS –Stainless Steel AL –Aluminum Alloy CI- Carbon
Steel P/K –Polypropylene/Kynoar
Maximum Applied Temperature Limits (diaphragm / ball / seal material)
Acetal ···············································40°- 150°F
(4.4- 65.5°C)
Santoprene·········································-40°- 225°F
(-40°- 107.2°C)
·················································40°- 220°F (4.4°-
104°C)
Nitrile··················································10°- 180°F
(-12°- 82°C)
Viton····················································-40°-
350°F (-40°-176.6°C)
Hytrel····················································-20°-150°F
(-12°- 93°C)
Kynar·····················································10°-200°F
(-28.9°- 65.5°C)
Polypropylene··········································32°- 175°F
(0-79.4°C)
1” Flow diagram
