Air Operated Double Submersible Diaphragm Pump Corrosion Resistant
Air Operated Double Submersible Diaphragm Pump Introduction
The air operated diaphragm pumps use compressed air as power
source, and it is the most advanced
type of diaphragm pumps in market for the moment. It adopts
three-way air pilot valve to achieve real
no dead stop and faster reversing. It is widely applied in waste
water treatment, chemical industry,
petrochemical industry, painting, ceramics, environmental
protection, printing and dyeing, etc. to deal
with all kinds of corrosive, volatile, flammable, poisonous fluids
with particles and high viscosity.
Air diaphragm pump(also know as a Membrane pump, air operated double diaphragm pump(AOOD) or pneumatic diaphragm pump)that uses a combination of the reciprocating action of a
rubber,thermoplastic or diaphragm and suitable valves either side
of the diaphragm (check valve,butterfly valves,flap valves,or any
other form of shut-off valves) to pump a fluid.
Air Operated Double Submersible Diaphragm Pump Parameters
| Item | Description | Unit | Reference Figure |
| 1 | Maximum air inlet pressure | Mpa | 0.83 |
| 2 | Maximum flow rate | L/Min | 192 |
| 3 | Maximum lift | M | 70 |
| 4 | Maximum outlet pressure | Mpa | 0.83 |
| 5 | Maximum particle size | mm | 3 |
| 6 | Weight | kg | 12.3 |
| 7 | Noise level | db | ＜70 |
Air Operated Double Submersible Diaphragm Pump Specifications
Air Diaphragm Pump
1. Non leakage
2. Good self priming performance
3. Convey all kinds of medium
4. Material:Cast steel,Alu,SS,PP
A 2 5 X X - X X X - X (model selection)
Form of pipe mouth:A-BSP B-NPT(F) C-Flange
Diaphragm material:9 – Santoprene H – Hytrel T - PTFE/Santoprene
Ball material:9 -Santoprene H – Hytre T – PTFE A - Acetal
Ball seat material:P/K –Polypropylene/Kynoar SS –Stainless Steel
Pump material: SS –Stainless Steel AL –Aluminum Alloy CI- Carbon
Steel P/K –Polypropylene/Kynoar
Maximum Applied Temperature Limits (diaphragm / ball / seal material)
Acetal ··············································40°- 150°F
(4.4- 65.5°C)
Santoprene·······································-40°- 225°F (-40°-
107.2°C) ···············································40°- 220°F
(4.4°- 104°C)
Nitrile···············································10°- 180°F
(-12°- 82°C)
Viton················································-40°- 350°F
(-40°-176.6°C)
Hytrel················································-20°-150°F
(-12°- 93°C)
Kynar················································10°-200°F
(-28.9°- 65.5°C)
Polypropylene·····································32°- 175°F
(0-79.4°C)
1” Flow diagram
