High Pressure Air Driven Double Diaphragm Pump For Foodstuff
Pharmaceutical
What are Air Driven Double Diaphragm Pump ?
These are pumps without any electrical motor and run with an air
pressure ranging from 1.3 to 8.0 bar. They are simple to run with
minimum maintainance cost and down time. All type of liquids can be
pumped. Only the MOC and capacity of pumps will vary depending on
application and buyer requirements. Sizes vary from 1/4" to 3" and
they are available in PP, PVDF, SS & Aluminium Models.
Air Driven Double Diaphragm Pump Parameters
| Item | Description | Unit | Reference Figure |
| 1 | Maximum air inlet pressure | Mpa | 0.83 |
| 2 | Maximum flow rate | L/Min | 192 |
| 3 | Maximum lift | M | 70 |
| 4 | Maximum outlet pressure | Mpa | 0.83 |
| 5 | Maximum particle size | mm | 3 |
| 6 | Weight | kg | 12.3 |
| 7 | Noise level | db | ＜70 |
Air diaphragm pump(also know as a Membrane pump, air operated double diaphragm pump(AOOD) or pneumatic diaphragm pump)that uses a combination of the reciprocating action of a
rubber,thermoplastic or diaphragm and suitable valves either side
of the diaphragm (check valve,butterfly valves,flap valves,or any
other form of shut-off valves) to pump a fluid.
Air Driven Double Diaphragm Pump Pumping for :
1. Waste water
2. Volatile liquid
3. Flammable and explosive liquid
4. Highly toxic liquid
5. Corrosive liquids: Strong acid and alkali
6. High temperature liquid
7. Viscous liquid: Food industry, Glue, Coating
A 2 5 X X - X X X - X (model selection)
Form of pipe mouth:A-BSP B-NPT(F) C-Flange
Diaphragm material:9 – Santoprene H – Hytrel T - PTFE/Santoprene
Ball material:9 -Santoprene H – Hytre T – PTFE A - Acetal
Ball seat material:P/K –Polypropylene/Kynoar SS –Stainless Steel
Pump material: SS –Stainless Steel AL –Aluminum Alloy CI- Carbon
Steel P/K –Polypropylene/Kynoar
Maximum Applied Temperature Limits (diaphragm / ball / seal material)
Acetal ···············································40°- 150°F
(4.4- 65.5°C)
Santoprene········································-40°- 225°F
(-40°- 107.2°C) ···············································40°-
220°F (4.4°- 104°C)
Nitrile················································10°- 180°F
(-12°- 82°C)
Viton·················································-40°- 350°F
(-40°-176.6°C)
Hytrel················································-20°-150°F
(-12°- 93°C)
Kynar················································10°-200°F
(-28.9°- 65.5°C)
Polypropylene·····································32°- 175°F
(0-79.4°C)
1” Flow diagram
